H3C Technologies H3C S12500-X Series Switches - Manual (Page 16)

9
Configuring basic VXLAN features
VXLAN configuration task list
Tasks at a glance Remarks
(Required.) Setting the forwarding mode for VXLANs N/A
(Required.) Creating a VXLAN on a VSI N/A
(Required.) Configuring a VXLAN tunnel N/A
(Required.) Assigning a VXLAN tunnel to a VXLAN
To extend a VXLAN to remote sites,
you must assign VXLAN tunnels to
the VXLAN.
(Required.) Mapping an Ethernet service instance to a VSI
Perform this task to assign customer
traffic to VXLANs.
(Optional.) Managing MAC address entries
You can add static remote MAC
addresses.
When network attacks occur,
disable remote-MAC address
learning to prevent the device from
learning incorrect remote MAC
addresses.
(Optional.) Confining unknown-unicast floods to the local site
Perform this task to suppress
unknown-unicast floods to the
transport network.
(Optional.) Configuring the destination UDP port number of VXLAN
packets
N/A
(Optional.) Configuring VXLAN packet check
Perform this task to check incoming
VXLAN packets, including the
following items:
• UDP checksum.
• 802.1Q VLAN tags in the inner
Ethernet header.
(Optional.) Enabling ARP flood suppression N/A
(Optional.) Configuring VXLAN packet statistics N/A
Prerequisites
Before you can configure VXLANs, you must perform the following tasks:
1. Set the system operating mode to standard by using the system-working-mode standard
command.
2. Save the configuration.
3. Delete the binary .mdb next-startup configuration file.