H3C Technologies H3C S12500-X Series Switches - Manual (Page 30)

23
# Verify that the VXLAN tunnels have been assigned to the VXLAN.
[SwitchA] display l2vpn vsi verbose
VSI Name: vpna
VSI Index : 0
VSI State : Up
MTU : 1500
Bandwidth : -
Broadcast Restrain : -
Multicast Restrain : -
Unknown Unicast Restrain: -
MAC Learning : Enabled
MAC Table Limit : -
Drop Unknown : -
Flooding : Enabled
VXLAN ID : 10
Tunnels:
Tunnel Name Link ID State Type
Tunnel1 0x5000001 Up Manual
Tunnel2 0x5000002 Up Manual
ACs:
AC Link ID State
FGE1/0/1 srv1000 0 Up
# Verify that the VTEP has learned the MAC addresses of remote VMs.
display l2vpn mac-address
MAC Address State VSI Name Link ID/Name Aging
cc3e-5f9c-6cdb dynamic vpna Tunnel1 Aging
cc3e-5f9c-23dc dynamic vpna Tunnel2 Aging
--- 2 mac address(es) found ---
2. Verify that VM 1, VM 2, and VM 3 can ping each other. (Details not shown.)
Multicast-mode VXLAN configuration example
Network requirements
As shown in Figure 9 :
• Configure VXLAN 10 as a multicast-mode VXLAN on Switch A, Switch B, and Switch C to provide
Layer 2 connectivity for the VMs across the network sites.
• Manually establish VXLAN tunnels and assign the tunnels to VXLAN 10.
• Use the default remote-MAC address learning method (MAC address learning in the data plane).