ATL Telecom AM100 User Manual
Page 4
ATL User Guide
AM100 M
Modem
7.
COMPLIANCE NOTES
The TTE network statements and the declaration of conformity statement to EC directive
1999/5/EC are provided inside the front cover of the AM100 User Guide together with safety
information.
7.1
TELECOMMUNICATION STANDARDS
The equipment is in conformity with the following International/National Standards.
ETSI EN300386 V1.2.1
EMC Requirements for Telecommunication Network Equipment
EN60950-1: 2002
Information Technology Equipment - Safety
G.703
Physical/Electrical Characteristics of Hierarchical Digital Interfaces.
V.11
Electrical characteristics for balanced double-current interchange
circuits operating at data signalling rates up to 10 Mbit/s.
V.35
Data transmission at 48 kbit/s using 60-108 kHz group band
circuits
ATL User Guide
AM100 M
Modem
4
ATL User Guide
AM100 M
Modem
The AM100 DC unit is defined as class II equipment, an EARTH conductor must be connected to
the M3 stud on the rear panel of the unit when using the G.703 interface in accordance with ITU-
T G.703 requirements.
Statement Safety Statements traffic ports:
The Line Port has a safety status of TNV-1
The Interface Port has a safety status of EARTHED SELV.
The G.703 Port Connection Port has a safety status of SELV when connected to Unexposed
Environments:
The G.703 Port Connection Port has a safety status of TNV-1 when connected to Exposed
Environments:
Definitions:
Exposed Environment
A TELECOMMUNICATIONS NETWORK is considered to be an exposed environment if one or more
conditions for an unexposed environment are not fulfilled.
Unexposed Environment
A TELECOMMUNICATIONS NETWORK is considered to be an unexposed environment if the
following conditions apply to all parts of the network.
a) The possible effect of indirect lightning has been reduced by measures described in IEC 61312-
1.
b) The possibility of having different earth potentials has been reduced by connecting all
equipment within the network to the same equipotential bonding system (see HD 384).
c) The possibility of power cross/contact has been reduced (see HD 384).
d) The possibility of induced transients and voltages has been reduced.
Manufacturers Declaration*
ATL Telecom Limited declares that this product is in conformity
with the essential requirements of the 'R&TTE directive 1999/5/EC'.
*A copy of the Declaration of Conformity is available upon request from ATL Telecom Ltd.
21