Marantz NA7004 - Manual (Page 17)

11
ENGLISH
Getting Started
Connections
Basic Operations Basic Operations
Advanced Operations
Troubleshooting
Explanation terms
Information
Specifi
cations
Index
[Using the remote controller]
Press the M-DAX button.
Each time this button is pressed, M-DAX changes as follows.
Off Low
High
Mid
The “M-DAX” indicator on the front display lights when M-DAX mode
is Low, Mid or High. (vpage 29))
NOTE
M-DAX is compatible with PCM (48 kHz or lower), MP3, WMA, AAC
and two-channel analog sources.
Switching the display’s brightness
Press [DIMMER] .
100% 75%
50% 25% Off
• The display’s brightness switches each time the button is pressed.
• If you operate the buttons when the display’s brightness is set to
“Off”, the display temporarily lights at 25% brightness level.
• The “DISPLAY OFF“ indicator on the front display lights when
Dimmer is set to “Off”.
Listening with headphones
Plug the headphones into the headphone jack (PHONES).
Adjusting the Volume
Turn .
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Operations possible during playback Tuner playback
Tuning in Broadcast Stations
Connect the antenna beforehand (vpage 5).
1 Press [TUNER] to select the reception band.
DAB FM
AM
2 Tune in the desired broadcast station. (FM/AM only)
When a station is received, the “ ” will light.
q To tune in automatically (Auto tuning)
Press [MODE] to light the “AUTO” indicator on the display, then
use [TUNING +, TUNING –] to select the station you want to hear.
w To tune in manually (Manual tuning)
Press [MODE] to turn off the display’s “AUTO” indicator, then
use [TUNING +, TUNING –] to select the station you want to hear.
• If the function is set to something other than “TUNER”, press
[TUNER] to switch the function to “TUNER”.
• The function can also be switched to “TUNER” turning .
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold [TUNING +, TUNING –]
to change frequencies continuously.
• A humming sound may be heard when using a TV nearby while
receiving AM programs. If this happens, move the system as far
from the TV as possible.
n To stop auto tuning
Press [TUNING +, TUNING –] .
Setting the digital output
Set to output from the rear panel DIGITAL OUT terminal (COAXIAL,
OPTICAL).
During stop mode, press [DIG. OUT] .
Each time [DIG.OUT] is pressed, output from the DIGITAL OUT
terminal (COAXIAL, OPTICAL) on the rear panel is switched between
“On” and “Off”.
[Selectable items]
On : Outputs the digital signal.
Off : Digital signal is not output.
• When digital output is turned off, the “DIG.OUT OFF” indicator
lights.
• When digital output is turned off, you can enjoy high quality audio
output from the ANALOG OUT terminal.
• The “digital output off” has a memory retention function where
the settings remain stored and unchanged even when the power
is turned off.
1.NA7004N_ENG_0826.indd 11 1.NA7004N_ENG_0826.indd 11 2010/08/26 19:16:10 2010/08/26 19:16:10