Marantz SA-KI PEARL - Manual (Page 27)

21
NAMES AND FUNCTIONS
BASIC CONNECTIONS
BASIC OPERA
TION
ADV
ANCED CONNECTIONS
APPLICA
TION OPERA
TION
TROUBLESHOOTING
OTHERS
APPLICA
TION OPERA
TION
ENGLISH
SETTING THE DIGITAL OUTPUT
The settings can be made using the remote control.
The settings are retained even if the power is turned off so that
you can always hear tracks played the way you want.
Use the same procedures to change the settings again.
The settings can be changed when the track is stopped.
7
During the playback of the CD layer of
an audio CD or Super Audio CD
DIGITAL
OUT
¶
“Digital Output Off” operation
The digital output function is turned ON and OFF by pressing
the “DIGITAL OUT” button while the track is stopped. When
digital output is turned off, the “D OFF” indicator lights up on
the display.
• When digital output is not used, turn off the digital output
and enjoy better sound quality through analog output.
Note:
Digital signals are only output when playing Audio CDs or the
CD layer of Super Audio CDs.
They are not output when playing other media.
The “digital output off” has a memory retention function where
the settings remain stored and unchanged even when the disk
is changed or the power is turned off.
APPLICATION OPERATION
USING AS A D/A CONVERTER
(DAC MODE)
2.
1. Connect a device with a digital output, such as a CD
transport or MD recorder, to the unit's DIGITAL AUDIO
IN terminal located on the rear panel.
2. Press the DAC MODE button on the main unit or remote
control. The DAC MODE indicator on the front panel will
light up in blue.
3. The input signal's sampling frequency (32kHz, 44.1kHz,
48kHz, 64kHz, 88.2kHz, 96kHz) will be displayed on the
LCD.
Note:
• When the unit is in DAC mode, audio output is analog
only.
• This unit can input linear PCM signals with sampling
frequencies of 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz, and
96kHz.
Please do not input signals other than linear PCM signals
(such as CD-ROM, Dolby Digital, DTS, or AAC signals).
Signals other than linear PCM may generate noise and
damage the speakers.
• When the sampling frequency switches, such as when a
satellite broadcast switches from A Mode to B Mode, there
is a 1~2 second muting effect that may result in a brief audio
drop out.
• If the data in the connected device has excessive jitter and
playback is not possible, the LCD will display the following
message.
4. To exit DAC mode and return to disc playback mode, press
the DAC MODE button on the main unit or remote control
again. The DAC MODE indicator on the front panel will
turn off.
SA-KI PEARL_UN_01_Eng.indd 21 SA-KI PEARL_UN_01_Eng.indd 21 09.2.23 9:49:29 AM 09.2.23 9:49:29 AM