ILS ILS22G winXP - Manual (Page 27)

25
The form shows the approximate lowest and highest position measured in centimeters (in this case 89 cm as the lowest
setting, and 114 cm as highest). The positions are measured at the front (Presenter side) from ground up to the top of the
pedestal.
Note: There might be later Powerlift engines which go lower or higher, or have a different rise-time from lowest to highest
measured in seconds (current Powerlift installations go from 89 cm at the lowest setting, to the highest setting at 114 cm
in roughly 17.5 seconds). If in doubt, use Alt_A or the menu Adapt entry to change your findings.
If you are presenting at the ILS22 lectern, you can press the Down button in this ILS22Setup wizard until the motor stops
and the lectern can’t go any lower. Based on the measured lowest position, you can adjust lowest, highest and rise-time
values. Press the Mark lowest button and the following form will come up to allow you to adjust to an initial height.
Press the Down or Up buttons to elevate the pedestal into a required
default position. The approximate height values will be adjusted
accordingly.
Press the Next button to continue.