IDK MSD-54 Series - Manual (Page 131)

131
8.8.10 Test tone [TEST TONE]
Since test tone can be output only to specific speakers, you can check the position of the speakers.
･Test tone:
･OFF [Default]
･1 kHz
･400 Hz
･Speakers’ position:
･ALL [Default] ･FRONT LEFT ･REAR LEFT
･FRONT L/R
･FRONT RIGHT ･REAR RIGHT
･REAR L/R ･LOW FREQUENCY EFFECT ･REAR LEFT CENTER
･REAR L/R CENTER･FRONT CENTER ･REAR RIGHT CENTER
Note:
For “LOW FREQUENCY EFFECT”, only test tone of 30 Hz is output.
REAR
FLH
FLW FL FLC FC
FCH
FRC
FRH
FR FRW
LFE
TC
RL RLC RC RRC RR
FRONT
FLH
FLW
FL
FLC
FC
FCH
FRC
FRH
FR
FRW
LFE
TC
RL
RLC
RC
RRC
RR
Front Left High
Front Left Wide
Front Left
Front Left Center
Front Center
Front Center High
Front Right Center
Front Right High
Front Right
Front Right Wide
Low Frequency Effect
Top Center
Rear Left
Rear Left Center
Rear Center
Rear Right Center
Rear Right
[Figure 8.44] Position of speakers
1. To set the test tone using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
AUDIO
▲▼keys: Select “AUDIO”.
↓ SET key
[AUDIO]
TEST TONE ▲▼keys: Select ”TEST TONE”.
↓ SET key
[OUT1 TEST TONE]
O FF
▲▼keys: Select the desired test tone of OUT1.
↓
◄►keys
[OUT1 SPEAKER]
A LL
▲▼keys: Select the desired speaker of OUT1.
*
↓ ESC key: Returns to the previous screen.
* Only if you set the test tone to “1 kHz” or “400 Hz”, you can set a speaker.
For each output