IDK MSD-54 Series - Manual (Page 105)

105
8.6.11 Tracking [TRACKING]
You can set the tracking for analog RGB/ analog YPbPr input video.
･ Tracking: 0 to 63 [Default]: 0
This function can be performed only if the total number of input horizontal dots and the value set in ”8.6.1 The
total number of horizontal dots“ are the same.
1. To set the tracking using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
INPUT TIMING
▲▼keys: Select “INPUT TIMING”.
↓ SET key
[INPUT TIMING]
TRACKING
▲▼keys: Select “TRACKING”.
↓ SET key
[IN6 TRACKING]
0
▲▼keys: Set the tracking (0 to 63).
◄►keys: Select the desired input (IN6 to IN9).
↓ ESC key: Returns to the previous screen.
Note:
Tracking works only if analog RGB or analog YPbPr signals are input. It is disabled
and the message shown right is displayed in the followings cases: Analog video
signals are input, no signal is input, or video input is set to a channel other than IN6 to IN9.
IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8 IN9
N/A N/A N/A N/A N/A A A A A
A: Can be set only if analog RGB/analog YPbPr signal is input.
N/A: Cannot be set.
2. To set the tracking using commands:
@STK Set tracking
@GTK Get tracking
[IN6 TRACKING]
NOT AVAILABLE NOW
For each input port/input signal