Dynex DX-R20TR - Manual (Page 62)

Troubleshooting
61
Troubleshooting
Warning: Do not try to repair your TV combo yourself. Refer all servicing to qualified service
personnel. Do not remove the back cover. Your TV combo has dangerous electrical
voltages inside that may cause a fire or injury.
Note: Your TV combo may make occasional snapping or popping noises. This is caused by
materials in the cabinet expanding or contracting when the room temperature changes.
This is normal.
Symptom Solution
No picture or sound. Make sure that the power cord is connected
to a power outlet and that the outlet is
supplying power.
Make sure that your TV combo is not in Listen
mode.
Adjust the brightness and contrast.
Picture has snow. Make sure that the antenna is connected
securely.
Adjust the antenna.
Picture has double or triple
image. If you are using an inside antenna, try
installing an outside antenna.
Make sure that the antenna is connected
securely.
Make sure that the antenna cables and
connectors are in good condition. Replace
them as necessary.
Adjust the antenna.
Picture has wavy lines. You may be experiencing interference from
cars, motorcycles, fluorescent lights, or
overhead power cables. Try moving your
TV combo or adjusting the antenna.
No sound. Make sure that the sound is not muted.
Increase the volume.
Picture has no color. Adjust the color controls.
Picture is scrambled and sound is
poor. You may be tuned to a channel with a weak
signal. Try changing the channel.
DX-R20TR.fm Page 61 Thursday, January 18, 2007 3:19 PM