Analog Way Trans-Scaler XT - TSC550 - Manual (Page 10)

Chapter 4 : STARTING TRANS-SCALER XT™
PAGE 10
4-5. COMPONENT VIDEO INPUT
The Component Video signal, also called YUV (Y, R-Y, B-Y), or BETACAM ™ , is widely used in broadcasting and is
available on high-quality DVD players. The COMPONENT signal is transmitted on 3 coaxial cables, and also has a better
quality picture than COMPOSITE and S.VIDEO signals. The COMPONENT connectors are usually RCA (x3), or BNC
(x3) connectors.
CONNECTION
4-6. COMPUTER INPUT
This input is used to pass-through any High-Definition or Computer signals. The signal connected to this input is sent
directly to the display output. Also you may connect a Computer source (PC, MAC, WORKSTATION), or a high
definition source (progressive DVD player, HDTV). Use the VGA supplied cable (HD15 male/male) to connect a PC. For
the others sources you may need some adapters (not supplied).
4-7. DISPLAY OUTPUT
The TRANS-SCALER XT ™ is equipped with an HD15 female output connector. If your display device is equipped only
with 5 BNC input connectors : use an HD15 to BNC (x5) cable (please see connection schematic below).
The TRANS-SCALER XT
™ can provide an RGBHV (H & V Separate Sync.) or an RGBS (Composite Sync.) output
signal.
CONNECTION