AXING HoE 1-03 - Manual (Page 43)

2015-08-23 | © AXING AG Switzerland | We reserve the right not to be liable for any changes in design and layout, errors and misprints 9
4. Configuration
First of all, before you configure the settings for demanding media, you have to configure the settings for the
HoE connection.
4.1. Configuration of Media Input
In order to configure the synchronization settings, you have to log in through a browser on the device.
The device is equipped with static IP addresses which have been factory set. Please note that the HoE 1-03 has
two IP addresses – one for media input and one for media output.
In order to perform configuration for your media-playback, you have to set up a connection to the media input
IP address.
Before you are able to access the device, you have to make sure that the IP address of your laptop / PC, from
which you configure, is located in the same network segment as the HoE 1-03.
The factory IP address of HoE 1-03 (media input port) is 192.168.0.130. In order to configure the IP address
from Laptop / PC, please perform the following steps.
 Change the IP address of the PC / laptop, for example to 192.168.0.11:
Control panel > Network connections > LAN connection >Properties >
Internet protocol version 4 TCP/IPv4 > Properties > Use the following IP address:
Press OK to save.
 Establish a connection between media input port and your PC / laptop.
 Now enter the IP address 192.168.0.130 in the web browser.
You will be able to carry out the initial configuration after the call of the web interface.
4.2. Configuration of Media Output
The HoE media output port is configured through a web browser. The factory IP address is 192.168.168.55.
Before you are able to access the Media-Output-Port, you have to make sure that the IP address of your laptop
/ PC (from which you configure) is in the same network segment as your Media-Output-Port. Please follow the
instructions of 4.1. After entering the IP-address in your web browser, the Welcome window will open.
The IP- and MAC-address as well as the subnet mask can be changed under the menu item System. With the
button Apply the changes will be confirmed. These steps have to be repeated for each HoE 1-01 receiver with
their own IP-address.
To make sure that the HoE 1-01 devices can be reached correctly, you can enter the new IP-address in your
web browser to double-check. The menu window will open. If the settings are correct, the connected terminal
device already plays an info video.