Altera Santa Cruz - Manual (Page 21)

Chapter 2: Board Components 2–15
MICTOR Connector (J2)
© December 2008 Altera Corporation Santa Cruz, USB, MICTOR, SD Card HSMC Reference Manual
4. Disable the built-in USB-Blaster by shorting JP8 on the Cyclone III starter board.
This procedure creates a closed JTAG chain as shown in Figure 2–13 .
Table 2–13 lists the MICTOR connector board reference and manufacturing
information.
Figure 2–12. Configuring Cyclone III Starter Board to Control JTAG Chain Using MICTOR Connector
Open JP1 and JP2
Short TDI and
TDO pins of J4
Close JP8 with Jumper
J4
short
Figure 2–13. The JTAG Chain between the THDB-Sum Board and Cyclone III Starter Board
THDB-SUM Board Cyclone III Starter Board
MICTOR Connector
J2
MICTOR_TDO
MICTOR_TDI
MICTOR_TDI
MICTOR_TDO
HSMC
HSMC_TDO
HSMC_TDI
HSMC_TDI
HSMC_TDO
LF_TDI
LF_TDO
JP2 JP1 OPEN OPEN
TDI TDO
JTAG_TDO
LF_TDO
ADG3304 ADG3308
TDI
TDO
J4
CIII_TDO
SHORT
CLOSE JP8
TDI
TDO
TDI
TDO
MAX 3128
Built-in
Blaster
VCC25
USB3V
Cyclone III
Table 2–13. MICTOR Connector Board Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
J2 38-pin MICTOR Connector Tyco Electronics 2-767004-2 www.tycoelectronics.com