Portable Winch Gas-powered pulling/lifting winch PCH1000 - Manual (Page 8)

8
2) Figure 2: Remove the hex bolt holding
the safety lip and drum using the 11 mm
(7/16’’) wrench. Then, remove the
washer, the safety lip and the spacer
bushing;
3) Figure 3: Remove the drum from the
shaft. If necessary, you may push it
forward with two screwdrivers. Make
sure that the shaft key stays in place.
4) Figure 4: Insert the 85 mm (3- 3/8’’)
drum on the winch shaft. Insert the
washer, the safety lip and the spacer
bushing on the hex bolt and insert this
assembly in the hole of the shaft. Then,
tighten the hex bolt with the 11 mm
(7/16’’) wrench;
5) Figure 5: Insert the new rope guide in
position and tighten it using the two (2)
bolts.
IMPORTANT: Make sure that the rope
guide is not in contact with the capstan
drum.