Portable Winch Gas-powered pulling/lifting winch PCH1000 User Manual

Page 18

3) Figure 3: Wrap the rope around the drum and start winching. The winch will align itself

automatically with the load.

IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL

EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT
PLATE.

AFTER PULLING FOR A FEW SECONDS WITH THE TREE/POLE

MOUNT, RELEASE THE TENSION OFF THE PORTABLE CAPSTAN PULLING/LIFTING
WINCH

. CHECK THE SOLIDITY OF THE INSTALLATION AND TIGHTEN THE SLING

AGAIN.

3.3.5.2 With the vertical pull winch support (PCA-1264)

After the installation of the tree/pole mount (section 3.3.5), follow these steps:

1) Figure 1: Insert the vertical pull winch support onto the square tubing of the tree/pole

mount (PCA-1263), align the holes and insert the pulley;

2) Figure 2: Tighten the nut with your fingers until it touches the support. Then secure it with

the ‘’R’’ pin;

3) Figure 3: Attach the winch anchor hooks to the eye bolts of the vertical pull winch support;
4) Figure 4: Wrap the rope around the drum and align the vertical support pulley with the

rope axe and start to pull;