Portable Winch Gas-powered pulling/lifting winch PCH1000 User Manual

Page 16

4) Figure 2: Wrap the rope around the drum and start winching. The winch will align itself

automatically with the load.

IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL

EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT
PLATE.

MAKE SURE THE ANCHOR

ING VEHICLE’S HAND BRAKE IS ON AND

WORKING PROPERLY. POSITION BLOCKS BEHIND THE WHEELS TO PREVENT ROLL
BACK.

3.3.4 Using the winch support plate (PCA-1268) with Heck-Pack system for 50 mm
European balls (PCA-1266) and winch support plate adaptor (PCA-1265)

1) Figure 1: Bolt the winch support plate adaptor (PCA-1265) onto the Heck-Pack system

(PCA-1266) with the 4 bolts provided;

2) Figure 2: Insert the Heck-Pack on the ball and fasten it down with the lever;
3) Figure 2: Slide the winch support plate (PCA-1268) onto the square tubing of the winch

support plate adaptor (PCA-1265) and secure it with both the h

itch pin and the ‘’R’’ pin;

Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;

4) Attach the winch anchor hooks to the eye bolts (as shown in section 3.3.3);
5) Wrap the rope around the drum and start winching. The winch will align itself

automatically with the load.

Figure 19