Portable Winch Gas-powered pulling/lifting winch PCH1000 User Manual

Page 17

IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL

EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT
PLATE.

MAKE SURE THE ANCHOR

ING VEHICLE’S HAND BRAKE IS ON AND

WORKING PROPERLY. POSITION BLOCKS BEHIND THE WHEELS TO PREVENT ROLL
BACK.

3.3.5 Using the tree/pole mount with anchor strap (PCA-1263)

The tree/pole mount is intended to use with either the winch support plate (PCA-1268) or the
vertical pull winch support (PCA-1264). Therefore, you must first install the tree/pole mount. To
do this, follow these steps:

1) Figure 1:

Place the tree/pole mount at the base of the tree or pole. Insert the sling’s hook

into the anchor point on the left

; then feed the sling’s end through the ratchet system;

2) Figure 2: Slide the whole set-up upward to the desired height and remove the supplied

wrench;

3) Figure 3: Tighten the sling with the wrench while making sure the rubber pads are

properly positioned. The pads should offer maximum contact surface with the tree or pole.

3.3.5.1 With the winch support plate (PCA-1268)

After the installation of the tree/pole mount (section 3.3.5), follow these steps:

1) Figure 1: Insert the winch support plate onto the square tubing of the tree/pole mount

(PCA-1263) and fasten it down with the hitch pin

and ‘’R’’ pin;

Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;

2) Figure 2: Attach the winch anchor hooks to the eye bolts of the winch support plate;

Figure 19