Lingenfelter L350080197 Lingenfelter C5 Corvette Mini Tub Kit - Manual (Page 10)

Page 9.
28. Use a 90 degree pick to pull the panel
tight to the other mounting hole; this is the
hole to the front approximately 11” up.
29. Drill a 1/8” hole through the plastic panel
while holding in position, install a screw but do
not over tighten. Before permanent installation
it will be necessary to trim plastic to accept the
supplied black “J” nut in this location.
30. Make sure the panel is pushed tight
against the frame section shown and insert a
90 degree pick tool in the backside of the three
(3) hat brackets and modified bracket and
scribe a circle in each parts mounting hole on
the panel.
NOTE: Maker sure the modified bracket is in
it’s permanent location before scribing.
31. Remove the panel and drill four (4) 5/16”
holes that you marked on the panel.