2 connector pin out – Hall Research VSA-31-IP User Manual
Page 8
6
IP DUAL PORT CONTROLLER
2.2 Connector Pin Out
RS-232-A Connector: This 9-pin D-sub connector is normally used to connect to the
“Controlled” device, such as a Projector (though any serial device is acceptable).
RS-232-A PORT
Direction To/From Unit
PIN Definition
2 RxD
3 TxD
5 GND
7 RTS
Pulled
High
RS-232-B Connector: This 9-pin D-sub connector is normally used to connect to the
“Controller” device, such as a VSA-31 Receiver (though any serial device is acceptable).
This connector can also be used to power the VSA-31-IP unit. The power source must
be capable of 12-15 vDC @ 250 mADC minimum.
RS-232-B PORT
Direction To/From Unit
PIN Definition
2 RxD
3 TxD
4 DTR
Pulled
High
5 GND
6
PWR IN
12-15 vDC 250 mADC
7 RTS
Pulled
High
PWR connector: This is a standard 2.5mm plug connection. The unit’s power supply is
12-15 volts DC with a minimum rating of 250 mADC. Upon application of power from
the 2.5mm PWR connector or by the RS-232-B Pin 6, the 10/100 and Status LED’s will
either blink or become illuminated solid. Refer to Section 2.2 for a description of the LED
functions.
LAN connector: This is a standard RJ-45 Ethernet connection capable of be connected
to any 10/100 BaseT network.