Hall Research VSA-31-IP - Manual (Page 19)

Model VSA-31-IP
17
Command Purpose Reply Notes
<^B>GBB Get Modules
Serial Data Bits
Per Byte
<^B>Aaa
Where aa represents the Data Bits per
Byte as follows:
0 = 7
1 = 8
<^B>SBBaa
Where aa represents the Data Bits per Byte as
follows:
0 = 7
1 = 8 Set Modules
Serial Data Bits
Per Byte <^B>A
Must
REBOOT or
LOG OUT for
changes to
take effect
Note on IP Settings via port 23
If you are unable to access the unit’s
port 23 from your PC using the IP
Modules default or last known IP
address, it could be that the IP
address of the IP Module is not
compatible on your LAN. One way
around this is to connect your PC
directly to the IP Modules RJ45 port
using a cross over cable, or use a
switch or router not connected to
anything else but your PC and the IP
Module, and then configure your PC
for a static IP address compatible
with the current address of the IP
Module. If the IP Module has the
factory default of 192.168.123.199, a PC address of
192.168.123.nnn may be entered where nnn is any number except
199.