SIG SAUER BLASER Tac2 - Manual (Page 29)

29
18.2 Removing the scope
• Grasp the rifle with your left hand
around the fore-end and scope,
steadying the rifle on your upper thigh.
• Loosen the two screws on the side of
the mount a few turns with an 1/8“
allen key.
• Remove the scope.
18. Fixed scope mount
18.1 Mounting the scope
• Loosen the two screws on the side of
the mount a few turns with an 1/8“
allen key.
• Grasp the centre tube of the scope
with the right hand above the mount.
• Hold the fore-end of the rifle with your
left hand and steady the stock against
your upper thigh.
• Carefully locate the two round locating
pins of the scope mount in the oval
notches milled into the top right of the
barrel. Tilt scope to the left and hold it
in that position.
• Tighten the two screws on the side of
the mount hand tight with an 1/8“
allen key.
NOTE:
Make sure the mounting faces are
clean and free of grease!
The barrels of the Blaser R 93 LRS 2 bolt
action rifle are equipped with notches to
accept Blaser fixed scope mounts with 1“,
26 mm or 30 mm rings or rail or Zeiss
ZM rail. It is assumed that an authorized
dealer has fitted your scope correctly to
match the barre l .
R-93-LRS_2 6/8/01 2:32 PM Page 29