SIG SAUER BLASER Tac2 - Manual (Page 26)

26
16. Stock
16.3 Cheekpiece:
• After loosening cheekpiece knob the
cheekpiece can be moved up or down.
To remove the cheekpiece from the
stock just pull it out of the top.
• To maintain the same elevation of the
cheekpiece when removing and
installing adjust the cheekpiece stop to
the
d e s i red position.
• Loosen allen screw M5x30 with allen
key SW 3. To adjust the offset of the
cheekpiece add or remove spacers on
the inside.
16.4 Handre s t :
• Loosen the 2 allen screws (SW 4) and
remove handre s t .
• Add or remove spacers to set the
d e s i red height.
• Installation in re v e r s e .
The following adjustments are possible:
- Buttplate elevation
- Length of pull
- Cheekpiece height and off s e t
- Handre s t
16.1 Buttplate
• Loosen baseplate knob and move
buttplate to desired elevation and
tighten.
16.2 Length of pull
• Loosen allen screw (SW 4) and re m o v e
buttplate
• Loosen and remove allen screws (SW 4)
which hold the spacers to the base-
plate. Add or remove spacers to set the
d e s i red length of pull.
• Installation in re v e r s e .
N O T E :
• When installing 1 or 2 buttplate
spacers use allen screws M5x25.
• When installing 3 or 4 buttplate
spacers use allen screws M5x50.
R-93-LRS_2 6/8/01 2:32 PM Page 26