SIG SAUER BLASER Tac2 - Manual (Page 23)

23
• Flip the retaining latch down again and
push it back into its recess so that it
snaps into position (fig. 18).
• Lift the retaining latch in the
bolt housing.
• Now insert the bolt head with the
groove facing exactly upwards into the
bolt assembly over the firing pin as far
as the stop and hold it there.
NOTE:
To make this process easier, jiggle the fir-
ing mechanism up and down with the
thumb of the other hand (fig. 17).
fig. 17 fig. 18 fig. 19
NOTE:
If the retaining latch is not in the correct
position, a warning pin will project from
the outside of the rail (fig. 19).
14. Changing the bolt head
R-93-LRS_2 6/8/01 2:32 PM Page 23