Microtel Series 1000 - Manual (Page 28)

MICROTEL Series 1000 Dialer
22
Basic System Information
The following commands configure and report the current values for the system level
information of the Series 1000. A Glossary of Dialer Terminology that defines these
parameters with respect to Series 1000 operation is provided in the Appendix.
z Voice System Name The name the dialer will say in introduction before making any
report.
*001
Play system name
**001~ Record system name
Once the command to Record the system name has been typed in, the Dialer will
respond by saying ‘Ready’. When you hear this, speak the message. Once you have
finished speaking, you can either wait until it finishes recording or press the ‘#’ key
to trim off the end of the message. If the message is trimmed, type ‘*001’ to replay
the message.
Example voice responses-
Microtel SERIES 1000 (default in the normal system voice)
-or-
Jonesburg remote site number 6 (recorded)
z Call Spacing Delay This is the number of minutes the dialer will wait after an
answered Callout before beginning any other Callouts (01-99 minutes).
*002 Review call spacing
**002MM Program call spacing
Example- Command:
**00260
Response: The call delay period is six zero minutes.
z Ring Count The number of rings the dialer will see before answering an incoming
call.
*003
Review ring count
**003nn Program ring count
Example- Command:
**00305
Response: The ring count is five.