Microtel Series 1000 - Manual (Page 26)

MICROTEL Series 1000 Dialer
20
Configuration
The configuration commands described in this section modify basic dialer operation and
store information about the dialer’s operational behavior in nonvolatile memory. You
should only have to configure your dialer once -- all changes are saved permanently,
even if AC and battery power are removed from your dialer. This section consists of the
following subsections:
z Basic System Information - Set/Query various system values
z Time/Date Setting - Set/Query the Dialer’s Time and Date
z Automatic Call-outs - Set/Query the Dialer’s independent Call At Times
z Telephone Numbers - Set/Query each of the outgoing phone numbers
z Input/Output Modules - Set/Query the I/O Point configurations
The following abbreviations are used in the manual to represent user-selected inputs in
the Dialer configuration commands:
Abbreviation Meaning
c I/O Channel Number, 1-8 (9 = power-fail), 1 is leftmost
DDHHMM Days(00-99), hours(00-23), minutes(00-59) - 000000 is disabled
HHMM Time in 24 hour format (0000-2359)
MMDDYY Date in month, day, year format
~ Recorded speech
n 1 digit numeric data
nn 2 digit numeric data
nnn 3 digit numeric data
nnnn 4 digit numeric data
t Variable length Telephone selections (up to 9 selections)
p Variable length Telephone number (up to 60 digits) with escape
codes
aaa 3 Digits corresponding to an Analog value (00.0 - 99.9%)
w Day of week (1=Sunday ... 7=Saturday, 9=all days)