FloAire Demand Control Ventilation System User Manual
Page 24
A0023662
May 2014 Rev.5
24
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor.
17. Set Min Prep Frequency(Factory Default: 10Hz)
This option is only displayed when Prep Time Mode is enabled. Its maximum value is the
minimum of the low frequencies of all the fans controlled by the package and minimum value is
5Hz.
Starting from the Main menu of HMI
, press DOWN or UP until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the screen displays “Set Min Prep Frequency”. Press
ENTER. Press UP or DOWN to adjust the Min Frequency. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor.
18. Hide Energy Savings(Factory Default: NO)
Starting from the Main menu of HMI, press DOWN or UP until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the scre
en displays “Hide Energy Saving”. Press
ENTER. Press UP or DOWN to choose YES or NO. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor.
19. CO Sensor Input(Factory Default:OFF)
Starting from the Main menu of HMI, press UP or DOWN
until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the screen displays “CO Sensor Input”. Press ENTER.
Press UP or DOWN to choose: ON or OFF. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor.
20. Set Min Room Temp(Factory Default: 50 Degrees °F)
Starting from the Main menu of HMI, press UP or DOWN
until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the screen displays “Set Min Room Temp”. Press
ENTER. Press UP or DOWN to adjust the set value. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor.
21. PCU CORE Only(Factory Default: OFF)
Starting from the Main menu of HMI, press UP or DOWN
until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the screen displays “PCU CORE Only ON/OFF”. Press
ENTER. Press UP or DOWN to choose: ON or OFF. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the
processor. NOTE: This will not be present if HOOD CORE is enabled under the Factory Options
menu.
i.
Set IO1 Delay Time (Factory Default: 0 min)
This option is intended for applications that require the fans to keep running for a specific amount of
time right after the BMS signal is turned OFF. The delay time value is set in minutes with a maximum
value of 15 minutes. The fans will remain ON for the set time after the BMS is de-energized.
Starting from the Main menu of HMI, press UP or DOWN until the screen displays “Misc Options”.
Press ENTER. Press UP or DOWN until the
screen displays “Set IO1 Delay Time”. Press ENTER.
Press UP or DOWN to adjust the set value. Press ENTER
Press MENU multiple times to get back to the main menu or one more time to reboot the processor.