Rocedures – Intertape Polymer Group (IPG) TWA 1000-M User Manual
Page 14

TWA 1000-M (U9701)
UDM 9701
14
S
ET
-U
P
P
ROCEDURES
Tape Loading
Feed Bar Location Setting
The Feed Bar has two positions. The
location is determined by the roll length
1. Position the adjustable feed roller based
on the roll length.
2. For larger, 1000 ft. rolls, locate the feed
roller to the most forward position
3. For smaller rolls, locate the feed bar to
the farthest outboard position
Figure 7-3
Tape Roll Carriage
The Roll Carriage houses the tape roll and
must be set up prior to use based on the roll
width and roll length
1. Open up the self centering side guides
using the adjustment knob to permit the
insertion of the tape roll
2. Place the tape roll in the roll carriage
with the tape tab feeding toward the
discharge end of the machine
3. Adjust the width of the side guides using
the adjustment knob so that they are
about 1/8” away from the edge of the roll
and do not restrict the unwinding of the
tape.
Figure 7-4
Tape Length Scale
Side Guide
Adjustment Knob
Tape Roll Carriage
Feed Roller
(shown in small roll
position)
Feed Bar Location
For Large Tape Rolls
Feed Bar Location
For Large Tape Rolls