Operations, Precautions, Tuning the tv to your vtr 1 – Panasonic NV-HS1000EC User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV to your VTR
1
un
1,3
The VTR supplies a signal to the TV set via the RF coaxial
cable on channel 36.
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts.
If you have connected the VTR to the TV through the 21 -pin
scart terminal or Audio/Video/S-Video output sockets then
you do not need to follow the procedure mentioned below.
Operations
1
OPERATE
CD
Turn on the TV and VTR.
2
«---- S-VIDEOOUT
NORMAL^ □ jiTEST
SIGNAL
To generate a test pattern, set NORMAL/
S-VIDEO OUT/TEST SIGNAL to TEST
SIGNAL
3
Hi
Set the TV to an unused position which you
wish to use for your video playback.
4
S-VlDEOOUT
NORMAL^ □ (iTEST
SIGNAL
Set NORMAL/S-VIDEO OUT/TEST
SIGNAL to NORMAL
Note;
The test signal is transmitted on video channel 36. If you
are encountering interference from a TV broadcast on this
video channel, you may readjust to another free
channel (32'-40) by using the CH AOJ. screw which is
located on the rear of the VTR. When rotating the CH ADJ,
screw, take care not to turn it too far.
Please note that if the CH ADJ. screw is used then you will
have to retune your TV to the test signal as in item 2 to 4
above.