Panasonic CQVA70EU - Manual (Page 31)

Batteries for Remote Control
Battery Replacement:
1. Remove the battery holder.
Pull the holder by the Position B while
pushing Position A in the direction indi­
cated by the arrow.
2. Replace the battery.
Set a new battery properly with the (+)
side up as illustrated.
3. Insert the battery holder.
Push in the holder to the original position.
Remote control
Note on Batteries:
Old batteries must immediately be removed and disposed.
Battery Information:
• Designated Battery: Panasonic Lithium Battery (CR2025)
• Battery Life; 6 months with normal use (in normal room temperature)
Caution:
Improper use of batteries may cause overheating, explosion or ignition, resulting in injury or fire.
Battery leakage may cause damage to the unit.
• Do not disassemble or short the batteries. Do not throw the batteries into the fire.
• To avoid the risk of accident, keep the batteries out of reach of children.
Maintenance and Care
Maintenance
Your product is designed and manufactured to ensure a minimum of maintenance. To clean the exterior of
this unit, use a soft cloth to wipe the surface. Do not use benzine, thinner, or any other type of solvent.
Product Service
This unit should only be serviced by qualified technicians. Service information is not provided for cus­
tomers.
Should your units ever require service, refer to the MITO service department listed in the Warranty card
for detail instructions.
Replacing the Fuse
Be sure to use a fuse of the specified rating (3A, 10A) when replacing a blown fuse. Fuses with higher ca­
pacity ratings, use of any substitute, or connection without a fuse may result in a fire hazard or damage to
the unit. If the replacement fuse fails, consult the MITO service department for detail instructions.
CQ-VA70EU
31