Tuning the tv to your vcr, Nv-hd670a, Operations – Panasonic NV-HD670 User Manual

Page 9: Note, Tuning the tv to your vcr nv-hd670a

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Tuning the TV to your VCR

NV-HD670A

The VCR supplies a signal to the TV via the RF coaxial

cable on channel AU37.

It is possible to view the video picture on your TV in the

same way that you watch TV broadcasts.

If you have connected the VCR to the TV through the

video and audio input sockets, then you do not need to
follow the procedure below.

Operations

;si

POWERc!)/)

Turn on the TV and the VCR.

TEST

SIGNAL

OFF ON

To generate a test pattern, set

RF OFF/

TEST SIGNAL

to ON.

Note;

The test signal is transmitted on video channel AU37. If
you are encountering interference from a TV broadcast on

this video channel, you may readjust to another free
channel (AU31-43) by turning the CH ADJ. screw located
on the rear of the VCR.
When rotating the CH ADJ. screw, take care not to turn it
too far.

Note that if the

CH ADJ.

screw is used, then you will have

to retune your TV to the test signal following steps 2-4

above.