Panasonic NV-HD670 - Manual (Page 38)

Recording will not operate correctly
SYMPTOM CAUSE REMEDY CHECKED
The “ESI” indication
flashes whenever
recording is
attempted.
The erasure prevention tab
on the video cassette has
been broken off.
Use a tape with an intact erasure prevention tab, or
cover the tab hole with adhesive tape, if the original
recording is no longer required.
The picture is
recorded with noise
ora blank screen.
The aerial or aerial lead is
defective. Check the aerial connection to the VCR. See page 8.
Check your normal TV picture. If there is no picture,
check your aerial.
The VCR is not correctly
tuned. Retune the VCR. See pages 11-13.
A1 or A2 has been selected. Select the required TV programme.
Timer recording
cannot be
performed.
The clock or calendar has
been incorrectly set.
Check the clock and calendar. Set them to the
present time. {Note that this is a 24-hour clock.)
See page 16.
The recording starting or
ending time setting is
incorrect.
Set the recording starting and ending time correctly.
The VCR has not been set
for timer recording. Press TIMER REC after programming for timer
recording.
AV external
recordings cannot
be made.
A1 or A2 has not been
selected. Select A1 or A2 by pressing INPUT SELECT.
External AV connections are
incorrect, Check that the connections for external video and
audio sources are correct. See page 32.
SYMPTOM CAUSE ^^-'V'R emedytv ;..^ CHECKED
The remote
controller does not
operate correctly.
The remote controller
transmitter beam is not
reaching the VCR.
Ensure that the remote controller is being pointed at
the VCR and that the transmitter beam is not
obstructed.
The distance is too far. Use the remote controller within 7 m of the VCR. If
this range is not possible, replace the batteries.
The batteries are exhausted. Replace the batteries. Note the precautions for
replacement on page 7.
The batteries are incorrectly
fitted with (4-/-) reversed. Fit the batteries correctly as shown on page 7.