Panasonic NV-HD670 - Manual (Page 36)

Before Requesting Service
Before requesting service, check the following points again.
On Screen Display Messages
On screen display messages are displayed.
MESSAGE CAUSE REMEDY
PLEASE PUT IN
A VIDEO CASSETTE.
REC/OTR or TIMER REC
has been pressed without a
video cassette inserted.
Insert a video cassette with an intact erasure prevention tab.
PLEASE STOP TW E TAPE.
TUNER PRESET has been
selected during playback.
Stop the tape.
PLEASE SET THE CLOCK,
TIMER REC, G-CODE or
PROG./CHECK has been
pressed when the clock is not
set.
Set the clock.
PLEASE USE A CASSETTE
WITH TAB.
REC/OTR or TIMER REC
has been pressed without a
video cassette with an intact
erasure prevention tab. Use a video cassette with an intact erasure prevention tab.
NO TIMER RECORDING
HAS BEEN SET.
TIMER REC has been
pressed with no timer
programmes.
Set timer recording
TIMER PROGRAMMES ARE
FULL
G-CODE has been pressed
when 8 programmes have
been already set. Cancel unnecessary programmes.
VCR IS IN THE TIMER
STANDBY MODE.
POWER c!)/l (VCR Ci» has
been pressed during the
timer standby mode.
Press TIMER REC to release the VCR from the timer standby
mode.
DEW FORMED IN THE VCR.
Dew has formed. Wait until the message disappears.
Self-diagnostic Indications
This VCR has a self-diagnosis and display function. If the VCR detects trouble during installation or during use, the following
indications automatically appear in the VCR display, indications are in the form of a single English letter plus two numbers,
such as [HOI].
INDICATION CAUSE REMEDY
U 1 0 Dew has formed. Wait until the indication disappears.
HDD Some trouble has occurred.
{Numbers after H and F differ
according to the status of the
VCR.)
Consult Panasonic Customer Care Centre for advice on 132600.
(NV-HD670A only)
Consult your dealer for further advice.
F D D