Panasonic G-CODE NV-FJ620 - Manual (Page 2)

Warning and important
Information
As this equipment gets hot during use, operate it
in a weil ventilated piace; do not instali this
equipment in a confined space such as a book
case or similar unit.
important
Your attention is drawn to the fact that the recording of
pre-recorded tapes or discs or other pubiished or broadcast
materia! may infringe copyright laws.
Cautions before you operate this VCR
Avoid;
- Humidity and dust.
- Covering the ventilation holes with soft materials such as
cloth or paper.
- Extreme heat such as direct sunlight.
- Magnets or electromagnetic objects.
- Touching internal parts of the VCR.
- Water or some other liquid.
- Lightning. (Disconnect the aerial plug from the VCR during
lightning storms.)
- Anything heavy on the VCR.
- Connecting or handling the equipment with wet hands.
- Using a cell phone near the VCR because doing so may
cause noise to adversely affect the picture and sound.
Warning
To reduce the risk of fire or shock hazard, do not expose this
equipment to rain or moisture.
For your safety
Do not remove outer cover.
Touching internal parts of the VCR is dangerous, and may
seriously damage it.
To prevent electric shock, do not remove cover. There are no
user serviceable parts inside. Refer all servicing to qualified
service personnel.
Inserting Remote Control Batteries
Insert the batteries with the polarity (© and ©) correctly
aligned.
Notes:
The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the frequency
of use,
- When they are exhausted, replace them with two AA, UM3,
or R6 size batteries.
- When the batteries are exhausted, remove them
immediately and dispose of them correctly.
- Make sure that the batteries are inserted with the polarity
(© and ©) correctly aligned.
- Do not mix old battery with new battery.
- Do not mix different battery types, i.e. Alkaline and
Manganese.
- Do not use rechargeable (Ni-Cd) batteries.
- Do not heat or short-circuit the batteries.
- When you do not use the remote control for a long time,
take out the batteries and store them in a cool, dry place.
Do:
- Wipe the VCR with a clean and dry cloth.
- Install the VCR in a horizontal position.
- Keep the VCR, TV and other equipment switched off until
you have finished all connections.
Condensation may form in the following cases:
- The VCR is brought from cold surroundings into a
weii-heated room.
- The VCR is suddenly brought from cool surroundings,
such as an air-conditioned room or car, to a place which is
hot and humid.
Note:
- In any of the above-mentioned conditions, do not operate
the VCR for at least 1 hour.
This VCR is not equipped with a dew sensor.
Press the POWER button O to switch the VCR from on the
standby mode or vice versa. In the standby mode, the VCR
us still connected to the mains.
NV-FJ620A:
NV-FJ620EA: Australian model
New Zealand model
( Plug in Auto Tuning (NV-FJ620EA only)
On Screen Display
r:
Plug in Auto
Tuning is
completed.
All broadcasting stations that can be received in the area
are automatically tuned and stored in memory.
- Do not turn off the VCR halfway. (See page 6.)