Panasonic NV-FS1 - Manual (Page 16)

PLAYBACK
FIX
o o
TRACKING—SLOW
SOFT SHARP
PICTURE
Image Selector
Reset/lndex Button
S-VHS IMAGE
VTR/TV AUDIO SELECT AUDIO DUB INSERT
UZZI
REW/O— ---------PLAY---------- ----- G)/FF STOP
> » □
MEMORY
Preparation
•Make sure that the Timer Record Function is set to “Off”.
•Insert a recorded video cassette.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Turn the TV set on and select the video playback channel.
Rewind and Fast Forward
Press the Rewind ◄◄/Review @ Button to rewind the
tape.
REW/(53
Press the Fast Forward ►►/Cue © Button to wind the
tape forward rapidly.
@/FF
»
Lap Time Counter
It shows the elapsed recording or playback time.
—
. n ■ n /■/ n n
u ■ u u. u u
Hours^ i Seconds
I Minutes
The indication will appear when the tape is
rewound further than the tape counter position
“ 0 : 00 . 00 ”.
r
•If the figures on the Tape Counter do not change
during Fast Forward, Rewind or any of the Playback
functions, this means that nothing is recorded on
that tape section.
•The Tape Counter is automatically reset to
“0:00.00” when the video cassette is ejected.
PAUSE/STILL
SEAUCH
DO
RE$ET
I ^ I ^ I
Memory/Search Button--------------
Repeatedly pressing this button will change the indication in
the following order: “M” (Memory) ^ “S” (Search) ^ both
indications are off ^ “M”...
Memory Indication
I
Search Indication
n • n n n n
U ’ u u. u u
Memory Function
The Memory function makes it simple and fast to find a
certain position on the tape later again, simply by pressing
the Reset/lndex Button at that position to set the tape
counter to “0:00.00” and by pressing the Memory/Search
Button. During Rewind or Fast Forward, the tape will then
stop at approximately the desired position.
Image Selector
EDIT: For editing operations such as dubbing.
NORMAL: For ordinary use of the VTR.
DETAIL: For playing back a pre-recorded S-VHS casset­
te tape. In case of a tape recorded in the VHS
mode, this setting has not influence on the
operation.
•When the Image Selector is set to "EDIT", the
picture shaipness cannot be adjusted with the
Picture Sharpness Control.