Panasonic NV-HD70EA - Manual (Page 10)

Preparations for G-Code Programming
Setting Up the Remote
Controller for the G-Code
Programming
Before using for the first time;
It IS necessary to programme your G-Code remote
controller with your local TV station G-Code identification
number and the programme position of your VTR at which
those stations are received. This should be done for each
TV station for which G-Coae programmes are listed. Have
a newspaper or magazine on hand which lists today 's local
TV station programmes and G-Code numbers.
Preparation
• Tune tne TV to your VTR See page 5.
• Set the
Clock of the VTR. See page 6
• Store TV broadcasts into your VTR. See pages 8-9.
3
4
2.7
! TV station
Programme
position on VTR
1
identification |
Number
TV ONE 1 001
CHANNEL2 2 002
TVS 3 003
SKY TV MOVIES 4
1______________ _
004
SKY TV SPORTS 5
1
--------------------------------------------------------
005
i 1
1 ■ i ■
If you do not know the identification number of a TV
station for which a G-Code number is supplied, you
can determine the identification number by proceeding
as follows:
Operations Display Symbols
1 Open the door of the remote controller.
Keep CLOCK/PRESET pressed for
more than 2 seconds and then press it
again.
o
CLOCK'-'PRESET
n n I
U L< I
Enter a G-Code number listed in
newspaper against the first local TV
station in your area (say TV1).
U'J pc
( i 1 L Ou
• Enter the G-code number which is ahead of the
present time and date Otherwise the wrong
identification number will be generated.
• If you have entered the wrong number, press
CANCEL and then enter the proper number.
Press CONFIRM to set the identification
number.
n n I
U U I
Select the programme position of your
VTR which receives the TV station you
entered at step 3.
n n i
U Lt »
Select a G-Code number listed in
newspaper against the second local TV
station in your area (say TV2) and
repeat steps 3-5 until all G-Code
stations have been programmed into
the remote controller.
Press CLOCK/PRESET twice.
o
CLOCK PRESn
8
Close the door of the remote controller.