Panasonic NVG40 - Manual (Page 8)

INSTALLATION
Connection to a TV Set
NV-G40A:
FOR YOUR SAFETY
Install ant external aerial to AS 1417.1.
Used to attenuate the reception of the VHF and/or UHF
aerial signals. If the reception is normal, set to “HIGH”. If
the signal is strong {stripes appear in the upper part of the
picture), set to “LOW”.
O Connect the external aerial to the RF Input Socket of
the VTR.
0 Connect the aerial terminal on your TV set to the RF
Output Socket on the VTR with the supplied DIN-DIN
Coaxial Cable.
o Connect the AC Mains Lead to the AC Mains Socket of
the VTR to the mains outlet.
0 If the TV set is equipped with separate video and audio
input sockets, it is recommended to connect the VTR to
the TV set with separate video and audio cables.
TUNING THE TV SET TO THE
VIDEO PLAYBACK CHANNEL
Video Playback Channel Selector [NV-G40A, EA}
This switch is used to select the Video Playback channel
OFF- I ON
TEST
SIGNAL
o ©
Turn the TV set on and select the AV programme
position or another programme position that is not
occupied by any TV station.
Press the VTR On/Off Switch to turn the VTR On.
(FRONT SIDE)
VTR
•The corresponding indicator lights up.
0 Set the VTR/TV Selector to “VTR",
(FRONT PANEL)
VTR/TV
r~ I
O
©
•VTR Indicator will appear in the Multi-Function
Display.
Set the Test Signal Switch to “ON".
Tune the selected programme position (channel) of the
TV set to the VHF channel shown below for your
model. Confirm on the TV set that the received test
pattern is as shown below.
NV-G40A VHF channel 0 or 1‘
NV-G40EA VHF channel 2 or 3
-8-
*NV-G40A only
In some areas channel
0 may be used by local
TV station. In this case
switch to channel 1.
0 Set the Test Signal Switch to “OFF'. Your TV is now
ready to receive the RF output signal from the VTR.
0 To check, play back a pre-recorded tape and readjust
fine tuning of TV if nec^s^ry.