Panasonic NVG40 - Manual (Page 15)

RECORDtNG FROM A TV BROADCAST SIGNAL
Preparation
•Make sure that the Timer Record Function is set to "Off",
•Reset the Tape Counter to ‘‘0:00.00’’.
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Set the VTR/TV Selector to ‘‘VTR’’.
O Select on the VTR, the programme position (channel)
to be recorded. In order to confirm proper reception,
turn on the TV set and select the video playback,
channel.
/ n
i U
@ Press the Record Button (•).
REC#
n
REC
•When a video cassette with broken out tab is
inserted, it will be ejected automatically.
• During recording, the programme position (channel)
on the VTR cannot be changed.
•To start a recording with the Remote Controller, press
the two Record Buttons on the Remote Controller
simultaneously.
To Finish the Recording
^ Press the Stop Button (■).
If You Wish to Avoid Recording Unwanted Material
O
Press the Pause/Still Button (II) to stop the tape
temporarily.
PAUSE/STILL
REC
II
•Press the Pause/Still Button (II) again to continue
the recording.
•If you leave the VTR in the pause mode for more than
5 minutes, the VTR will automatically switch over to
the stop mode to protect the tape and the video
heads.
Recording One TV Programme While Watching
Another
(T) Record (following steps O and @).
@ Set the VTR/TV Selector to "TV".
(§) Select the desired programme position (channel) on
your TV set,
•Disconnect all cables from the Video Input and
Audio Input Sockets before starting the recording. If
they remain connected, it is impossible to record TV
programmes.
-
15
-