Panasonic PV-V4520 - Manual (Page 7)

‘Important; If the remote control POWER, ACTION, PROGA/CR+, CHA/ t , NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
6
CHANNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX,TUNE IT TO YOUR
LOCAL PBS CH THEN, . .
PLEASE PUSH CH UP KEY
Start Channel Auto Set
and Clock Auto Set.
Press CH ▲,
CH AUTO SET PROCEEDING
0
AUTO CLOCK SET
PROCEED ING
[ Case 1 ]
H
(Setup completed)
1/ 4/2000 TUE 12:00PM
DST:ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
END : PUSH CH UP KEY
Press CH A
to exit.
If your area observes DST (daylight
saving time), but the time is incorrect;
do the ‘Time Zone Adjust” steps on page 29.
IMPORTANT NOTE FOR
AUTO CLOCK SET
• Auto clock set is perfomned the
first time the VCR is turned off
each day. If used, a cable box
must be left on and tuned to the
PBS channel at the time VCR
power is turned off if you want auto
clock set to be done.
• If used, a DSS receiver must be
turned off for auto clock set.
• If Cable Box or DSS receiver is
connected to VCR via AudioA/ideo
jacks, an RF coaxial cable must
also be connected for auto clock
set and channel auto set features
to work.
[ Case 2 ] (Setup incomplete)
Clock Setup incomplete.
Set the clock manually.
1) Press ACTION.
AUTO CLOCK SET
tS INCOMPLETE
PUSH ACTION TO SET CLOCK
SET CLOCK \l/
SELECT MONTH
DST:ON
SELECT
SET
END
A ▼ KEY
► KEY
ACTION KEY
SET CLOCK
1/ 4/2000 TUE 12:00PM
DST: ON
ET COMPLETED
SET ► KEY
START : ACT I ON KEY
2) Press AT to
select month.
3) Press ► to set.
• Likewise, set date, year, time,
DST (Daylight Saving Time).
To Make Corrections,
repeatedly press ◄ ► to move to
error, then correct.
4) Press ACTION.
(Clock starts.)
• To exit this
mode, press
ACTION again.
* VCR calendar is accurately maintained to
Dec. 31, 2096 11:59PM.
■ Channel auto set selects normal TV or Cable
channels depending on your VCR hookup.
• To reset Language, Channels, Clock or
VCR’s Output Channel see pages 28 and 29.
------ Using ATM ► keys---------
You can also operate the menu
screen using VCR buttons.
When menu screens are
displayed, the PLAY, STOP,
REWIND, and FF buttons on
the VCR and remote function
as AT-^ ► only with no tape
inserted.
To exit the menu, repeat above
with or without tape inserted.
To display menu using VCR
buttons, press CH
A and CH
T together.