Panasonic PV-V4520 - Manual (Page 15)

‘Important: If the remote control POWER, ACTION, PROGA/CR+, CHA/T, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Cable Box Setup Process of Recording
Connection O @ 3 (ï!Q[o) [T> I Programming
Display menu.
Press ACTION.*
2
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
ID10МА/LANGUE: ENGU SH
VCR’ S OUTPUT CH:3
SELECT
SET
END :A ▼ KEY
:► KEY
: ACT I ON KEY
Select SET UP CHANNEL.
1) Press AT to
select.
2) Press ► to
display.
3
SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
WEAK SIGNAL DISPLAY : OFF
CABLE/DSS BOX SET UP
VCR P(us+ CH SET UP
SELECT
SET
END A ▼ KEY
► KEY
ACTION KEY
Select CABLE/DSS BOX
SET UP.
1) Press AT to
select.
2) Press ► to
display.
4
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
VCR^CABLE/DSS BOX^TV
VCRi’TV
SELECT
SET
END ;A T KEY
:► KEY
:ACT I ON KEY
Select your hookup
method.
1) Press AT to
select.
2) Press ► to set.
If CABLE/DSS BOX ►VCR ►TV,
go to step 5.
If other, press ACTION three
times and go to page 16.
5
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
CABLE/DSS BOX OUTPUT CH
SELECT
SET
END A ▼ KEY
< ► KEY
ACTION KEY
Select cable box or DSS
receiver output channel.
1) Press AT to
select.
2) Press ► to
enter.
If necessary, refer to your Cable
Box/DSS manual.
If you are using Audio/Video jack
connections, select and set
"VIDEO OUT’ as output channel.
here.
End setup.
Press ACTION twice.
VCR PlusH- and PlusCode
are registered trademarks of
Gemstar Development
Corporation. The VCR Plus+
system is manufactured
under license from Gemstar
Development Corporation.
15