Panasonic PV-V4520 - Manual (Page 6)

One Time VCR Setup
When VCR is turned on the first time,
setup mode is entered automatically.
Process of Setup
[)dajûg]ïE©3
O OïïSfô
Turn the TV and VCR on.
Press POWER*.
Set TV Channel to CH 3.
• If using AV. Cable connection, set TV
to Video instead of channel. (See
connection a) on page 4.)
2
C=>
SELECT LANGUAGE
PUSH CH A : ENGLISH
OPRIMIR CH
T : ESPAÑOL
APP. VCR/TV ; FRANÇAIS
TO CHANGE VCR'S OUTPUT
CH, PUSH ACTTION KEY.
Display SELECT LANGUAGE.
This display appears for first time setup
only.
Select the language.
Press ACTION
I IF YOU PUSH ACTION KEY.
VCR’S OUTPUT CH SWITCHES
TO CH 4.
CH y
for English
for Spanish
(ESPAÑOL)
(FRANÇAIS)
Press ACTION
ASE TUNE YOUR TV 1
4.
J After 3 seconds
When using connection b)
(see page 4), tune TV to VCR’s
output channel.
If there is beat or noise on CH3,
change VCR’s output channel to CH4
by pressing ACTION twice.
Always tune TV to this channel to monitor the VCR.
If you used audio/video jack connection, tune the TV to its video input.
If wrong language is set, do “Reset All VCR Memory Functions"
steps on page 30.
3
VCR^CABLE/DSS BOX^TV
VCR►TV
SELECT;A T KEY
SET :► KEY
END : ACT I ON KEY
Select hookup.
1) Press AT
to select.
2) Press ►
to set.
If you selected “CABLE/ DSS BOX ► VCR ► TV," continue with step 4
and only the cable box output channel will be placed in memory.
If not, go to step 6 .
4
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
CABLE/DSS BOX OUTPUT CH
SELECT: A T KEY
SET ► KEY
END :ACT I ON KEY
Select cable box
or DSS receiver
output channel.
1) Press AV
to select.
2) Press ►
to enter.
If necessary, refer to cable box manual.
If you used Audio/ Video jack connection to cable box, set “VIDEO OUT,
_____ ADCVOtT
CE) ŒD CS)
COLWtMftStt 01SPt*Y T*P€PbsintaH
t 1 l~ 1 I 1
PAUSE CM SKIP SPEED SEARCH,
CD O O 0 -1
SLOW
o
C H A / T
Model PV-V4520
remote is
shown here.
5
6
Turn on cable box and set it to PBS
channel in your time zone.
* If you use DSS receiver, it must be turned off.
For assistance, call 1-800-211-PANA(7262).