Industrial Injection LBZ/LMM Duramax Compound Turbo - Manual (Page 5)

16. Install the stock intake assembly and supplied EGR block off plates, and connect all connectors and wires.
Remove plas c cover over the wiring harness and wrap wiring harness with black electrical tape and move
wires away from hot pipe.
17. Install black Rubber 90 degree hose( Cut hose to size) and clamps and intake charge pipe and rotate compressor housing to
fit and ghten all clamps (Note: make sure there is an O-ring in the Intake charge pipe).
18. Once the turbo exhaust and compressor housing is adjusted to fit properly, ghten both the exhaust and
compressor clamps on the turbo. Install the air filter sensor in the supplied pipe and install the air filter
using the supplied clamps.
NEW EGR
BLOCK OFF
GASKETS