Bag b – Losi LOSB0289 Drift R Manual User Manual

Page 7

Figure 11

Step 1. Snap a 3/16" x 3/8" bearing (25) into the right side of the

idler pulley (23). The bearing will snap past the ridge and stop.

Step 2. Place the idler pulley shaft (22) through the idler pulley

(23) from the bearing side.

Step 3. Slide a #4 x .020 washer (9) over the 4-40 x 5/16" button

head screw (24).

Step 4. Insert the 4-40 x 5/16" button head screw (24) through the

idler pulley (23) and secure it to the belt tensioner arm (21).

Figure 11

Figure 10

BAG B

Step 5. Position the chassis (27) upside-down on your work bench.

Insert the belt (26) and pull it through both ends of the chassis (27).

Step 6. Pull the belt (26) out, just slightly, through the bottom of

the chassis (27) and insert the Steering tunnel (28), tall end forward,
into the slot in the front of the chassis (27). Press into position as
indicated in Figure 11.

The steering tunnel should now be located in between the belt,

with the belt still slightly hanging out of both ends of the car.

Figure 10

*NEVER PINCH THE BELT*

NEVER OVER TIGHTEN THE SCREWS IN THE CHASSIS - Team

Losi has designed interlocking features into the XXX-S chassis when

screws are to the point of being snug the parts are held firmly in place.