Losi LOSB0289 Drift R Manual - Manual (Page 17)

150 72
43
76
70
71
25
RIGHT
LEFT
BAG D (Continued)
14
Figure 31
Figure 31
Figure 30
Figure 30
!
Step 7. Apply a thin coat of red MIP thrust bearing/ assembly
grease (78), in the white tube, to the outside of the CVD coupling
(74). Insert the greased CVD coupling (74) into the large hole in the
CVD Axle (72) so that the cross-hole in the coupling (74) can be seen
through the slots in the axle (72).
!
Step 8. Place the CVD dogbone (73) over the CVD axle (72). Align
the holes in the CVD dogbone (73) with the hole in the CVD coupling
(74). Secure all three parts by inserting a 1/16" x 7/16" (solid) pin (75)
through the holes in the CVD dogbone (73), the slots in the CVD axle
(72), and the hole in the CVD coupling (74).
!
Step 9. Apply a small amount of Thread-lock compound (79), in
the black tube, to the set screw (82) before installing it.Center the pin
(75) in the CVD dogbone (73) and secure it by threading a 4-40 x 1/8"
set screw (82) into the end of the CVD coupling (74).
!
Step 10. Repeat Steps 7-9 for the second CVD assembly.
Apply the enclosed Thread-lock to the set screw before thread-
ing it into the CVD coupling. If Thread-lock is not used, the set
screw will loosen during operation. This will cause your car to stop
running.
74 75 82
!
Step 11. Thread a 3/16" ball stud (43) into the top side of the left
spindle arm (70) as shown in Figure 31A.
!
Step 12. Press a 3/16" x 3/8" bearing (25) into the outside of the
spindle (70).
!
Step 13. Slide a 3/16" x 3/8" bearing (25)over the axle (72). Next,
slide an axle spacer (71) over the CVD axle (72) against the bearing
(25).
!
Step 14. Press the axle (72) with bearing (25) into the spindle (70)
from the inside through the bearing (25) in the outside of the spindle
(70).
!
Step 15. Secure the CVD axle (72) and the spacer (150) by
inserting a 1/16" x 5/16" (spirol) pin (76) through the small cross hole
in the axle (72). The pin should be centered in the axle.
!
Step 16. Repeat Steps 11-15 for the right spindle.
25 43 71 150 76
THREAD
LOCK
72
74
82
75
73
RED
LUBE
Figure 31A