Losi LOSB0289 Drift R Manual - Manual (Page 11)

44
41
27
31
46
24
42
Figure 18
Figure 19
Using a medium grade sandpapper (i.e. 500 grit) clean the
excess material off the 5mm x 8mm bushings. This will ensure a free
working steering assembly.
"
Step 1. Thread a 3/16" ballstud (43), from the top side, into each
of the bellcranks (41), (42) as indicated in Figure 18.
"
Step 2. Insert a 5mm x 8mm bushing (45) into the top and bottom
of the left (41) and right (42) bellcranks.
Figure 18
Figure 19
BAG C
8
43
45
"
Step 3. Line up the hex on the steering post (44) with the hex area
on left side of the chassis (27). Press the steering post (44) to the
bottom of the hex in the chassis (27). Thread a 4-40 x 3/8" flat head
screw (31) through the bottom of the chassis (27) into the steering
post (44) as indicated in Figure 19.
"
Step 4. Slide the left bellcrank (41) over the steering post (44) on
the left side of the chassis (27).
"
Step 5. Place a steering cap (46) over a 4-40 x 5/16" button head
screw (24) with the flat end of the steering cap (46) towards the head
of the screw (24). Thread the button head screw (24) through the left
bellcrank (41) into the steering post (44).
The bellcrank should rotate freely.
"
Step 6. Repeat Steps 3 through 5 for the right bellcrank (42).
24 31 46
41
42
45
43
LARGE HOLES