Losi LOSB0289 Drift R Manual - Manual (Page 32)

38
37
134
27
140
141
27
139
138
BAG H (Continued)
29
Figure 63
Figure 63
Figure 64
Figure 64
!
Step 19. Cut a piece of two-sided tape (135) to the same size as
the bottom of the receiver (not included). Peel one side of the
backing off and stick the tape (135) to the bottom of the receiver.
!
Step 20. Make sure that the area on the chassis (27), between the
motor and the servo, is clean. Wipe this area off with a clean cloth or
rag.
Rubbing alcohol can be used to clean any oily residue that
may be present on the chassis or receiver. Allow the alcohol to dry
before applying the two-sided tape.
!
Step 21. Peel the backing off the the two-sided tape (135) and
install the receiver to the left side of the chassis (27), between the
motor and servo, with the antenna wire exiting the receiver towards
the center of the car as shown in Figure 63.
!
Step 22. Run the antenna up the center rib, in the chassis (27),
through the antenna mount (134) into the small hole. Press the
antenna mount (134) into the hole in the top of the center rib in the
chassis (27). Slide the antenna wire through the antenna tube (140) so
that the wire comes out the other end of the tube (140).
!
Step 23. While pulling the wire through the antenna tube (140),
slide the antenna tube (140) down and push it firmly into the antenna
mount (134) on the main chassis (27).
!
Step 24. Fold the wire down over the antenna tube (140) and
place the antenna cap (141) over the tube (140) and excess wire as
shown in Figure 63.
If antenna wire is shorter than the tube, remove the tube and
cut off enough of the tube so that the wire will extend about 3/4"
past the end of the tube. DO NOT cut off any excess antenna wire.
Doing so may cause you car to "glitch".
!
Step 25. Locate the gear cover (138) and cut the bottom side of it
along the trim line as shown in gray in Figure 64A. Drill three 1/8"
mounting holes in the gear cover (138) at the three locations marked
with dimples.
!
Step 26. Place the trimmed gear cover (138) over the spur gear
(36) and secure it with three 4-40 x 1/8" button head screws (139)
through the three open holes in the top of the chassis (27).
You may opt. to run the ESC wires through the gear cover with
the small cut-out on the bottom of the gear cover shown in Figure
64A. If you will be running the wires over the gear cover you should
leave that material there.
139
Figure 64A
37 38