Losi LOSB0289 Drift R Manual - Manual (Page 31)

The battery strap can be mounted in one of two ways to
accommodate different styles of batteries. If you will be running
matched-type cells, or individual cells laid out side-by-side, the TL
logo should be facing away from the top of the chassis as shown
in Figure 62 "B". If, however, you are using a pre-assembled stick
pack, the TL logo should be facing down towards the top of the
chassis as shown in Figure 62 "A".
!
Step 18. Once the battery pack (not included) is installed, the
plastic battery strap (137) will hold the batteries in place. The battery
strap (137) slides over the two posts (136) on the right side of the
chassis (27). The strap (137) is secured to the post with a body clip
(97).
122
87
90
100 99
97
96
90
98
97
A
137
136
B
97
BAG H (Continued)
28
Figure 60
Figure 60
Figure 61
Figure 61
Figure 62
Figure 62
97 122
!
Step 14. Install the front body mounts (90) into the two holes in
the front bumper (87) by lining up the tab on the body post (90) with
the slot in the bumper (87). Secure the two body mounts (90) with two
4-40 x 1/2" cap head screws (122) through the bottom of the bumper
(87) into the body mounts (90).
!
Step 15. Slide the foam bumper (100) over the two body mount
posts (90) with the large curved side toward the front of the chassis.
Slide one plastic washer (99) over each of the body mounts (90) until
they rest on the foam bumper (100). Secure the foam bumper (100) and
plastic washers (99) with a body clip (97) through the bottom-most
hole in the body mount (90).
!
Step 16. Position a body mount swivel (98) over each of the two
front body mount posts (90). Align the holes in the swivel (98) with
the seventh hole from the top of the front body mount (90). Secure
the swivels (98) with a body clip (97) through one side of the swivel
(98) and into the body mount (90) into the swivel again. Do this for
both front body mounts.
!
Step 17. Position a body mount swivel (98) over each of the two
rear body mounts (96). Align the holes in the swivel (98) with the
eighth hole from the top of the rear body mount (96). Secure the
swivels (98) with a body clip (97) through one side of the swivel (98)
into the body mount (96) into the swivel again. Do this for both rear
body mounts (96).
97
FRONT
REAR