Hollywood Racks HR1000 SportRider 2 bike version 2 - Manual (Page 5)

Pre- position the wheel trays to fit the bike’s wheel base (center to center
distance between the wheel axels) such that they are directly beneath each
wheel. To adjust the wheel trays, loosen the knobs and slide along the wheel
holder support tube. Tighten knobs securely.
To fit the first bike (closest to the vehicle) more easily, the vertical post may be
tilted down (away from vehicle). To do this, simply remove the side retaining pin
per fig. 21 to 23. Note: Never fold down main tube with bike(s) mounted. Place
the first bike in the wheel holders, and then rotate the vertical post up. See
figure 24. Handlebars for the first bike should be on the driver’s side of the
vehicle. If carrying two bikes, always load the smaller bike first (position the
smaller bike between the vehicle and vertical post)
Be sure that the hooks are well supported on the bike’s frame and tighten the
knob securely
. Use the Velcro strap on the wheel holder as the final step of
installing the bikes on the rack, per Fig. 27B.
Repeat for the outside/second bike with the short hook.
5
To fold the wheel tray tubes up, rotate and remove the front retaining pins, rotate the tube and replace the pins
INSTALLING THE BIKES ON THE RACK: