Motion drive beit removal, Fuse replacement, Repair and adjustment – Craftsman 917.254611 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REPAIR AND ADJUSTMENT
17. Motion Drive Beit Removal
Tile tractor drive ben maybe replaced wflthouttools. Park the
tradoron level area. Engage parking brake. NOTE: A BELT
INSTALUTION DECAL IS UNDER LEFT FOOTREST.
a Remove mower {See page 21),
b.
Remove two retainer springs from belt guide
bracket below transaxle pulley Remove bracket
(Fig. 22).
c.
Swing belt guides away from belt, toward rear of
tractor (Fig. 22).
d Roll bell over top of transaxte pulley.
e Roll belt over engine pulley and off idler (Fig 23).
I, Release parking brake. f^H belt as far as possible
over top of clutch pulley.
g.
Reset parking brake. Pull belt over top of clutch pul
ley (Fig, 23).
h.
Pull belt out through shift gate to remove from trac
tor (Fig 24)
i Install belt by reversing above procedure
A
REPLACE BELT ONLY WITH THE BELT
LISTED IN THE REPAIR PARTS SEC
TION OF THIS MANUAL.
18. Fuse Replacement
Replace with 30 amp automotive-type plug-in fuse The
fuse holder Is located under the dash
FIGURE 22
ENGINE
FIGURE 23
19