Craftsman 917.276310 - Manual (Page 11)

The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage. Always wear safety glasses
or eye shields while operating your tractor or performing any adjustments
or repairs. We recommend standard safety glasses or a wide vision safety
mask worn over spectacles.
HOWTO USEYOURTRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine
is running, any attempt by the operator
to leave the seat without first setting the
parking brake will shut off the engine.
1. Depress dutch/brake pedal all the way
down and hold.
2. Pull parking brake lever up and release
pressure from dutch/brake pedal.
Pedal should remain in brake position.
Make sure parking brake will hold trac­
tor secure.
Push-In to
"Disengaged” Attachment Clutch
Choke \ Switch Pull Out To
Contro! \ “Engage”
Throttle
Control
“Brake”
Positi
Clutch/
Brake Pedal
“Drive”
Parking'
Brake
“Engaged”
Position
"Disengaged”
Position
Position Height Adjustment
Knob
STOPPING
MOWER BLADES -
• To stop mower blades, push attachment
clutch switch in to disengaged position.
GROUND DRIVE -
• To stop ground drive, depress clutch/
brake pedal all the way down.
• Move gearshift lever to neutral (N) posi­
tion.
ENGINE-
• Move throttle control between half and
full speed (fast) position.
NOTE: Failure to move throttle control
between half and full speed (fast) posi­
tion, before stopping, may cause engine to
“backfire”.
• Turn ignition key to “STOP” position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
use.
11
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch
in any position other than "STOP" will
cause the battery to discharge and go
dead.
NOTE: Under certain conditions when
tractor is standing idle with the engine run­
ning, hot engine exhaust gases may cause
“browning” of grass. To eliminate this pos­
sibility, always stop engine when stopping
tractor on grass areas.
^CAUTION: Always stop tractor com­
pletely, as described above, before leaving
the operator's position.
TO USE THROTTLE CONTROL
Always operate engine at full throttle.
• Operating engine at less than full
throttle reduces the battery charging
rate.
• Full throttle offers the best mower perfor­
mance.
TO USE CHOKE CONTROL
Use choke control whenever you are start­
ing a cold engine. Do not use to start a
warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE forward and backward
The direction and speed of movement is
controlled by the gearshift lever.
1, Start tractor with dutch/brake pedal de­
pressed and gearshift lever in neutral
(N) position.
2, Move gearshift and range shift levers
to desired position.
3, Slowly release dutch/brake pedal to
start movement.
IMPORTANT: Bring tractor to a complete
stop before shifting or changing gears.
Failure to do so will shorten the useful life
of your transaxle.
TO ADJUST MOWER CUTTING HEIGHT
The cutting height is controlled by turn­
ing the height adjustment knob in desired
direction.
• Turn knob clockwise (r^) to raise cutting
height.
• Turn knob counterclockwise (t^) to
lower cutting height.