IOGear GCE616U - Manual (Page 10)

1
2
3
DVI KVM Cable
Local Computer
10
Setting Up
Setting up the GCE611U / GCE616U DVI KVM Extender system is simply a matter of plugging
in the cables. Make sure that all the equipment to be connected up is powered off. Refer to the
installation diagram on the following page and do the following:
1. Plug the DVI KVM cable supplied with this unit into appropriate ports on the front of the
Local Unit;
2. Plug the other end of the DVI KVM cable into the appropriate ports on the local computer.
Each connector is marked with an appropriate icon to indicate what it is.
Note: If you are integrating GCE611U / GCE616U with a KVM switch, the other end of the
DVI KVM cable plugs into the appropriate ports on the KVM switch.
3. For control of serial devices, connect the RS-232 serial port on the local unit to a serial port
on the local computer.