Apple Qmaster 2 and Compressor 2 (Distributed Processing Setup) - Manual (Page 69)

Appendix Command-Line Usage 69
Command options
This table provides information about each of the command options for
monitoring batches.
Monitoring command option Description
[-clustername ] Use to specify the name of the cluster to which the job was sent.
[-clusterid
address:port number>] Optionally, you can use -clusterid to enter the cluster ID and port
number instead of using -clustername.
Or, if you used -clustername and the cluster requires a password,
use -clusterid to specify the user name and password. (You need to
include the IP address: port number as well whenever you use
-clusterid.)
Tip: Use Apple Qmaster -show or Compressor -show to see a cluster’s
IP address and port number.
[-jobid -batchid
] Use to specify the job you want to monitor.
When you use the -jobid option, you must also specify the -batchid,
in the form of the name that was given to the batch when it was
submitted. (The batchid and jobid are displayed after a batch is
submitted.)
If you do not use the -jobid option, all the jobs submitted to the
specified cluster are listed.
[-timeout ] Use to specify the number of seconds before Batch Monitor can
quit when looking for a cluster. The default value is 0, which puts
no limit on the timeout and allows Batch Monitor to browse the
network for as long as it needs to find the cluster.
[-query ] Use to specify how frequently, in seconds, the job status should be
updated.
[-kill -jobid -batchid
] Cancels the specified job or batch.
[-help] Displays information about supported options for Batch \ Monitor.
UP01082.Book Page 69 Wednesday, March 16, 2005 5:12 PM